Showing results 1 to 25 of 150
Search took 0.01 seconds.
Search: Posts Made By: gunmetalgray67
Forum: Pontiac - Street 10-22-2020, 03:33 PM
Replies: 21
Views: 2,130
Posted By gunmetalgray67
That sounds pretty good. I have a 12 bolt for it...

That sounds pretty good. I have a 12 bolt for it but its a 1969 so its a little bigger and I'm trying to optimize as much tire under it I can fit. It's being mini-tubbed right now.
Forum: Pontiac - Street 10-22-2020, 03:14 PM
Replies: 21
Views: 2,130
Posted By gunmetalgray67
If you don't mind me asking...How much was the...

If you don't mind me asking...How much was the QuickTime 9 Inch? I ask because that's who UMI suspension guys recommended going with for my 67 Lemans convertible which has a similar setup to your...
Forum: 66-67 GTO Tempest & LeMans TECH 05-26-2014, 11:50 PM
Replies: 18
Views: 318
Posted By gunmetalgray67
My top just stopped working today as I went to...

My top just stopped working today as I went to put it up. It went about 1/3 of the way up and stopped so I turned switch to "down" and the top went down. It makes no sound with switch in "up"...
Forum: Pontiac - Street 05-26-2014, 11:21 PM
Replies: 35
Views: 1,288
Posted By gunmetalgray67
Schroeder, Its insanely expensive to do all...

Schroeder,

Its insanely expensive to do all AN fittings and hose...I should know I did it. I thought it would look cool and I needed to replace my whole fuel system anyway. I have all black...
Forum: 67-92 Firebirds & Trans Ams FOR SALE 08-28-2013, 06:35 PM
Replies: 8
Views: 926
Posted By gunmetalgray67
Poster removed ad

Poster removed ad
Forum: 61-77 GTO, Tempest & LeMans Parts For SALE 08-28-2013, 06:26 PM
Replies: 3
Views: 219
Posted By gunmetalgray67
Are these still available?

Are these still available?
Forum: Missing Pontiacs, Parts or Trailers 04-11-2013, 04:14 PM
Replies: 2
Views: 375
Posted By gunmetalgray67
Spring Carlisle coming up at the end of the ...

Spring Carlisle coming up at the end of the month, have people look for them there.
Can't imagine they are worth that much for scrap but to sell them cheap at car show they might go quickly. Good...
Forum: Pontiac Business Entities Exchange 09-26-2012, 06:44 PM
Replies: 3
Views: 232
Posted By gunmetalgray67
Yes I contacted Racekrafters and set up an...

Yes I contacted Racekrafters and set up an appointment. Unfortunately, I couldn't get one until the end of October.
Forum: Pontiac - Street 09-13-2012, 03:59 PM
Replies: 8
Views: 457
Posted By gunmetalgray67
Who is Slawco? Never heard of them.

Who is Slawco? Never heard of them.
Forum: Pontiac - Street 09-12-2012, 06:10 PM
Replies: 8
Views: 457
Posted By gunmetalgray67
Any experience with Racekrafters? I knew about...

Any experience with Racekrafters? I knew about them but they had alot of disparaging remarks about them on some of the other blogs. I see that they have been in High Performance Pontiac alot lately...
Forum: Pontiac - Street 09-11-2012, 06:47 PM
Replies: 8
Views: 457
Posted By gunmetalgray67
I know about Spotts. I have bought and sold...

I know about Spotts. I have bought and sold parts with him at Carlisle. Does he work on cars too? I thought he just built engines. Besides Hatfield is about 2 hours each way. A great option I am...
Forum: Pontiac - Street 09-11-2012, 04:19 PM
Replies: 8
Views: 457
Posted By gunmetalgray67
Exclamation Engine work in central PA

I need some work done on my Pontiac here in central Pennsylvania. Hopefully near Harrisburg. I need someone to check out the engine while in the car. I do not want to pull it if possible. Compression...
Forum: Pontiac Business Entities Exchange 09-10-2012, 09:24 PM
Replies: 3
Views: 232
Posted By gunmetalgray67
Engine work in central Pennsylvania

I need some work done on my Pontiac here in central Pennsylvania. Hopefully near Harrisburg. I need someone to check out the engine while in the car. I do not want to pull it if possible. ...
Forum: Pontiac - Race 06-05-2012, 09:09 PM
Replies: 10
Views: 339
Posted By gunmetalgray67
Thanks. I am going to pull the carb and I am...

Thanks. I am going to pull the carb and I am checking to see how much spacer will fit under the flat hood. I use a K & N 3 inch filter.
As far as the heat issue I am not sure because I have left...
Forum: Pontiac - Race 06-01-2012, 04:11 PM
Replies: 10
Views: 339
Posted By gunmetalgray67
I've had to put the car back into a storage unit...

I've had to put the car back into a storage unit until I figure it out. The carb doesn't seem to be dripping any fuel down the venturies. What's the best way to find a very small pin hole or leak? ...
Forum: Pontiac - Race 05-31-2012, 06:27 PM
Replies: 28
Views: 838
Posted By gunmetalgray67
My 76 TA had 2.56 rear with a mild 400, 6x heads,...

My 76 TA had 2.56 rear with a mild 400, 6x heads, Performer intake and Q-jet and an automatic and ran 14.7 hazing 16 inch street tires past the 60 ft. mark. Horrible 2.30 sec. 60 ft. times. The...
Forum: Pontiac - Race 05-30-2012, 06:45 PM
Replies: 10
Views: 339
Posted By gunmetalgray67
Thanks My cell is aluminum and does have the...

Thanks
My cell is aluminum and does have the ROVV (roll over vent valve) in the bulkhead fitting.

I guess I will start looking closer at the carb for a stuck float or something.
Forum: Pontiac - Race 05-30-2012, 06:11 PM
Replies: 10
Views: 339
Posted By gunmetalgray67
Yes it is an unburned smell. The braided...

Yes it is an unburned smell.
The braided lines are only 2 years old.

Should the overflow line have a filter on it or a check valve at the end?
Forum: Pontiac - Race 05-30-2012, 04:08 PM
Replies: 10
Views: 339
Posted By gunmetalgray67
Unhappy Gas smell??

My 1967 Lemans convertible emits a very strong smell of gasoline and it makes the garage smell of gas too.

Not that it should matter but the engine is a 468 (400 with Eagle stroker crank and...
Forum: Pontiac - Street 05-30-2012, 04:07 PM
Replies: 2
Views: 223
Posted By gunmetalgray67
Unhappy Gas smell

My 1967 Lemans convertible emits a very strong smell of gasoline and it makes the garage smell of gas too.

Not that it should matter but the engine is a 468 (400 with Eagle stroker crank and...
Forum: Suspension TECH 11-18-2010, 11:01 AM
Replies: 4
Views: 305
Posted By gunmetalgray67
I have a Tallon Hydroboost with a stock steering...

I have a Tallon Hydroboost with a stock steering pump and a 87 Monte SS steerring box on my 67 Lemans convertible.

Call Tallon Hydraulics and talk to them. They were great to deal with and...
Forum: Pontiac - Street 11-10-2010, 05:08 PM
Replies: 47
Views: 1,973
Posted By gunmetalgray67
Run the Torker II. Performer will not breathe...

Run the Torker II. Performer will not breathe enough.
Forum: Pontiac Business Entities Exchange 10-04-2010, 03:21 PM
Replies: 5
Views: 183
Posted By gunmetalgray67
Thanks. I have dealt with Paul several times. ...

Thanks. I have dealt with Paul several times. Great guy. Bought and sold parts with him at Carlisle. Looking for more of a shop for the whole car...suspension, brakes, inspection, etc. Also,...
Forum: Pontiac Business Entities Exchange 08-24-2010, 10:52 PM
Replies: 5
Views: 183
Posted By gunmetalgray67
Looking for speed shop near Harrisburg, PA

Just moved back to Harrisburg, PA and need some work done on my 67 Lemans convertible. Are there any decent mechanics or speed shops that do professional work on high performance engines and parts. ...
Forum: Pontiac Business Entities Exchange 08-24-2010, 10:35 PM
Replies: 7
Views: 285
Posted By gunmetalgray67
This should work... www.tallonhydraulics.com/ ...

This should work...
www.tallonhydraulics.com/

I'll try and post pics of the installation on my 67 Lemans convertible tomorrow.
Showing results 1 to 25 of 150

 
Forum Jump

All times are GMT -4. The time now is 12:59 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017