| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
 |
|
Menu
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
|
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
#1
07-29-2012, 07:59 PM
|
||||
|
||||
67 GTO Partial quarter panel replacement help
Hi,
I have to replace the lower panel on my left quarter panel. Should I do a butt weld after I cut the quarter or make a crimp on the new and old panels then over lap and weld them? Thanks Jack 1967 GTO |
|
#2
07-29-2012, 11:12 PM
|
|||
|
|||
|
Butt weld, using small tack welds an inch or so apart, then gradually fill in the gaps to minimize warping. At least this method has worked for me, although some may offer different advice.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
