[69camarox]

Hi I was wondering if anyone could give me the correct measurements to mount my "gto" emblems on the front fenders ??

Thanks Bruce

[1969 Ram Air]

Ames Peformance has the measurements and a diagram. They sent me one, but I can't find it. Call them and they can send it to you.

[GTO JOHN]

I have a homemade template if you cannot get one from Ames.

[69camarox]

hi john might you just have a measurement up from the lower body line and mabey one from the rear edge of the fender ??

thanks bruce

[GTO JOHN]

Bruce, I can provide measurements. Will post tomorrow night. John

[69camarox]

that would be great thanks........ bruce

[69camarox]

John any luck getting me those measurements?? or anyone else willing to measure their car ??

thanks Bruce

[gto4evr]

From the body line up to the front of the G is 6-1/2” to the centerline of the emblem
From the body line up to the back of the O is 6-1/4” to the centerline of the emblem
From the rear edge of the fender at the door to the edge of the O is 2-5/16”

Remember, the GTO emblem should be horizontal to the ground, not to the body line.

Later,
Dennis

[69camarox]

thanks Dennis