FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
||||
|
||||
runner length on HSD intake?
Anyone know the runner length on a HSD intake?
|
#2
|
|||
|
|||
I have one I can measure for you tonight. Tell me how you would like me to take a measurement so we can compare "apples to apples".
|
#3
|
||||
|
||||
Just measure the length of the divider wall (common wall).
|
#4
|
|||
|
|||
OK, will post an answer around 7-8pm.
|
#5
|
|||
|
|||
My dividers have the leading edge modified some, how much from as cast I have no idea. I measured about half way up the side. And the face at the port openings has been milled a touch.
ports 1/3- about 5 1/4 inches long ports 2/4- about 6 1/4 inches long ports 6/8- about 5 1/4 inches long ports 5/7- about 6 1/4 inches long |
#6
|
||||
|
||||
But you get slightly different numbers depending on which side of the runner you measure
__________________
Skip Fix 1978 Trans Am original owner 10.99 @ 124 pump gas 455 E heads, NO Bird ever! 1981 Black SE Trans Am stockish 6X 400ci, turbo 301 on a stand 1965 GTO 4 barrel 3 speed project 2004 GTO Pulse Red stock motor computer tune 13.43@103.4 1964 Impala SS 409/470ci 600 HP stroker project 1979 Camaro IAII Edelbrock head 500" 695 HP 10.33@132 3595lbs |
#7
|
|||
|
|||
Just measured my manifold, it is unmodified in any way. Measurements were taken in the middle allowing the tape measure to follow the curve of the center divider.
1-3 5-1/2" 5-7 6" 2-4 6" 6-8 5-1/2" |
Reply |
|
|