| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
07-01-2008, 10:07 PM
|
|||
|
|||
455 motor mount question
I bought a set of anchor motor mounts for my 455 in a 70 GTO. The right side fits perfect but the left side does not. There is a 1/8 inch gap at the back of the mount between the frame motor mount and the inside edge of the anchor mount where the bolt goes thru. Can I put a harden washer to fill the gap? Any advice?
|
|
#2
07-02-2008, 08:23 AM
|
||||
|
||||
|
Had the opposite problem you have on one of my '70 455 cars. Had to take a 5lb hammer and spread it a tad. The washer will work if you can't see it.......
Motor mounts are pretty forgiving and repros are not precision units either. JW |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
