FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
||||
|
||||
Driveshaft Wanted
Looking for a 48.5 in. driveshaft for my 74 Formula 455 car. TH400 -12 rear. Will pick up within 50 miles. NEED FOR NORWALK !! Thanks, jim
|
#2
|
||||
|
||||
Driveshaft Wanted
If you don't find one closer, I have one down here in south Florida. I ship them all over the country with no problems. If interested, e-mail me: drolds1@bellsouth.net.
|
#3
|
|||
|
|||
I have a few ones from later years w/ TH350/ 10 bolt. you will need to swap yokes.
in hackettstown, nj, |
#4
|
||||
|
||||
How are you measuring, it, Just measured the two I have here, I thought they were from T350 cars, one is 50 1/2 and one is 50 from the outisde of the loops for the u-joints, also the 50 1/2 inch the u-joints look like 1 1/4 diameter and the 50 inch the u-joint are 1 1/8 diameter, they both have yokes on them and will be @ Norwalk.
|
#5
|
||||
|
||||
Gary, measure from the center of U-joint to center of U-joint. I'd be interested in one if it's 48".
|
#6
|
||||
|
||||
Mine mesures 48.5 center cup to center cup. Car had BBC wich 350 trans. Hoping to pick up the right u joint in the morning. I will let U know how i make out.. jim
|
#7
|
||||
|
||||
Would love to buy a used to bolt right in!! ROCKETMAN269V if I can't get it done for norwalk, I will email u about shipping me one.
|
#8
|
||||
|
||||
RST, the two I have measure 49 1/4 and 48 1/2 from center cup to center cup, looks like you have the 48.5 one already.
|
#9
|
||||
|
||||
Had to rework both ends with joints to make it work. Was looking to buy one to bolt right in today. More work but it worked out ok. Hope to c u norwalk.. Thanks Jim
|
Reply |
|
|