FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
|||
|
|||
Repro parts place aluminum tripower 66 manifold
Has anybody use this manifold? I have heat cracks in the lowers plenum floor as well as down the side of the center carburetor bore and across the top between the throttle bores. so I have to try something different? They have been making them long enough I would assume the quality is good and the fit is good but can’t find anything on this tripower site talking about it in the last couple years.. are the 2018/19 units well done? Anyone?
Last edited by 2+2=421; 03-04-2019 at 12:19 PM. |
#2
|
||||
|
||||
I bought one two months a go from The Pontiac Tripower team it looks ok some port alignment work is needed and some rough edges smoothed in the plenum area.
Have not try it out on a engine for fit But it look like it will work. http://www.pontiactripower.com/catalog/1966-tripower Last edited by Red GTO 66; 03-05-2019 at 06:10 PM. |
Reply |
|
|