[Craig Hendrickson]

Originally Posted by rtanner

i dont know if anyone makes the ho racing headers any more but if you can get w ken crocie and find out, they are the best

I'm certain the H-O Racing Tri-Ys are no longer available (shame about that). A pair occasionally shows up on ePay though.

[Don 79 TA]

i run the dougs on my TA and REALLY like them and SUPER easy to install
they are 1 7/8 though
I think only hooker, headman, and mad dog make 2" tubes

i dont have ground clearance problems, but i run a 27" tire all around
everything else stock height

I had no issues with the Dougs D ports either (for the very short period of time i had them on)

I will say with any header installer, try to use header studs, or at least ARP 5/15 header bolts.... almost makes the installs to easy

[Larry Navarro]

I've seen a nice set of Doug's headers that were cut and sectioned at the down tubes to provide additional ground clearance for a pro-touring trans am.

[uneasyrider]

Originally Posted by Skip Fix

About the only other header with more clearance is Tirbal Tubes Tri Ys. I autocrossed my 78 with 23" road race slicks and dropped springs and there was a speed bump in the tech area and I never dented my Hookers.
Pretty sure Hooker and Hedman are the only ones in a 2". Ron is currently starting 2" tri Ys. But most of the 600+ Hp Engine Master motors run 1 7/8. The Cleggs 455 SD Super Stocker that runs in the 9s has Dougs.

Thanks Skip! I'll look into the Tri-Y's too. I'm waiting for my taxes to get back and then I'm getting a set.

Thanks for all the input everyone, it was very helpful.