FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
||||
|
||||
Bronze Distributor gear not drilled all the way through for dowel pin
I was just installing a bronze distributor gear on my Mallory distributor when I noticed the hole for the dowel pin was not drilled all the way through. Is this normal? I was thinking if I wanted to replace the gear I would have to cut it off. The gear is part Mallory part number 29434.
I was going to put it on a drill press and just drill out the other side, but wanted to see if this was common or a defect.
__________________
67 Firebird 467 cubic inches 7.71 @ 92 in the 1/8 and 11.69 @ 115 in the 1/4. |
#2
|
||||
|
||||
I've used two of them and the hole went all the way through.
|
#3
|
||||
|
||||
I was thinking it should go all the way through, but was not sure because I know these gears are designed to be sacrificial. I will take it out to the shop and use a drill press to drill out the other side.
Thank you.
__________________
67 Firebird 467 cubic inches 7.71 @ 92 in the 1/8 and 11.69 @ 115 in the 1/4. |
Reply |
|
|