#1  
Old 02-01-2023, 06:54 PM
n20ta2's Avatar
n20ta2 n20ta2 is offline
Ultimate Warrior
 
Join Date: Dec 2007
Location: Cape Cod MA
Posts: 1,000
Default 1969 gto rear bumper impact brackets WTB

I have two of the same side now, anyone have a pair there not using? These are the small end brackets that mount to the tail panel at the quarter edge. If someone has a single I would take that as well. Just need to figure out wich one I need.

__________________
1969 GTO street strip project 11.1 forged 461, highport heads
1995 Trans-am 420 ci sb 14:1 compression 9"ford
9.89@132 1.34 60ft SOLD!
  #2  
Old 02-04-2023, 10:37 PM
orangegtojudge orangegtojudge is offline
Member
 
Join Date: May 2009
Location: Conyers, GA
Posts: 44
Send a message via Yahoo to orangegtojudge
Default

Leave both sides on the shelf. The bumper will fit the car quarters panels much closer and better without these brackets.

  #3  
Old 02-05-2023, 05:36 PM
John Eiseman's Avatar
John Eiseman John Eiseman is offline
Senior Member
 
Join Date: Dec 2009
Location: Woodland,Wa.
Posts: 232
Default 69 End Bumper Brackets

Have a set of these brackets here.

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 04:14 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017