| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
11-07-2020, 09:21 PM
|
|||
|
|||
400 auto tranny shifter issue
This is in my 72 Lemans. Original rebuilt tranny, and first time in car for me. If I shift from drive to neutral (where it stops), it's still in drive. I have to push down on top of shifter to push forward more to find reverse. How do I remedy that?
|
|
#2
11-08-2020, 08:49 AM
|
||||
|
||||
|
Adjust Cable/lever joint at Trans.
|
|
#3
11-08-2020, 09:22 AM
|
|||
|
|||
|
Loosen back-drive adjuster and get the shift cable/lever adjusted right first.
https://forums.maxperformanceinc.com...d.php?t=845426 Then adjust back-drive so column lock works. Along with neutral safety and back-up lights. Clay |
|
#4
11-08-2020, 08:12 PM
|
|||
|
|||
|
I did the adjustment by the book. I did eventually get my back up lights to work correctly. I just needed to adjust the neutral safety switch a bit. It seems I need more adjustment at the tranny lever. As in a bit more slot opening to slide my shift cable back a bit more. The tranny shifts into neutral at the shifter stop from reverse fine. But, going from drive to reverse, the shifter hits its stop, but hasn't quite shifted the tranny to actual neutral,
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
