| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
03-28-2013, 07:55 PM
|
|||
|
|||
Headers hitting control arm bolt
Have a set of Doug's long tube headers that I have finally been able to do my mock up with eng in the car.The dr side header is hitting the rear control arm bolt I bought the car in pieces but the headers were still in the box the part number is correct for 66 GTO with d port Edlebrock heads.Anyone run into this the part number is d567 . I removed the rear control arm bolt and it looks like it will need to be cut at least a half an inch will this leave enough room for alignment shims the car has no shims in it now have been doing a complete frame off restoration.
|
|
#2
03-29-2013, 05:15 AM
|
||||
|
||||
|
I had to cut mine when i put Hookers on it. I now have Dougs and there is a lot more clearence.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
