Prev Previous Post   Next Post Next
  #1  
Old 05-26-2020, 05:41 PM
NeighborsComplaint's Avatar
NeighborsComplaint NeighborsComplaint is offline
Ultimate Warrior
 
Join Date: Aug 2009
Location: Elgin
Posts: 1,901
Default Intake swap and SharkHide aluminum protectant.

Now that my car is out of the body shop. I am detailing it up a bit under the hood with some engine paint. I have to pull the intake off (ProComp RPM clone) to get at the valley pan which has some rust from a thermostat housing leak. The stock bolts were too long and bottoming out before clamping the water neck tightly. I am also replacing the headers with new ones of the same make that seem to have a much better coating than the old ones.

Since the intake is coming off, I can reinstall the ProComp (car seems to run just fine with compared to the old Street Dominator I had before it) but also also have a nice square bore Torker II I could thrown, Do you think I'd like the Torker II as well as the ProComp intake for the street? The carburetor and car are much more responsive off idle and midrange than with the old Street Dominator I was running. Would I even notice the difference between the Torker II and the ProComp when I put my foot in it?

I picked up a QuickFuel Slayer to try on it and intend to coat the carb it with Sharkhide Aluminum Protectant to try and keep the polished appearance. Curious if anyone has tried it on the polished carbs?

I am told 2K clearcoat turns yellow from heat and is also affected by gasoline fumes. My old polished Holley Street Avenger discolored immediately and looked like a junkyard carburetor in about 2 months. I have taken it off and polished it with a Dremel with no success. It literally oxidizes overnight in the summer humidity.

__________________
Triple Black 1971 GTO. 455 + .040", Block zero decked and align honed. SD Forged rods, forged SpeedPro pistons, crankshaft oil holes chamfered, polished and balanced. 6x-8 heads with 1.77" exhaust valves, bowls blended, port matched and smoothed. Crane 284281 (234/242 @ .050 duration w. .488/.505 lift), Crane Hi-Intensity lifters, Crane 99838 springs & retainers. ProComp RPM clone w. 750 Quick Fuel Slayer, FlowTech headers, TH400 w. Hughes GM25 convertor, 3.55 BOP 10 bolt.
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:36 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 

Cold Case Radiators

Cold Case Radiators is a Max Performance company that produces high end aluminum performance radiators at a price point that won't break the bank. Polished and stamped tanks. 2 rows of 1" tubes. Lifetime Warranty.

GTOG8TA.com

GTOG8TA.com is a Max Performance company that manufacturers parts for the 04-06 GTO, 08-09 G8, and 93-02 Firebird/Trans Am platforms.

Copyright © 2017