| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
04-27-2024, 12:00 PM
|
||||
|
||||
Tool Options for Checking Roller Springs with Head On?
Hey Everybody,
What are some options for Roller Spring checking tools with heads on - more on the budget side? Thanks, Craig |
|
#2
04-27-2024, 12:12 PM
|
|||
|
|||
|
https://forums.maxperformanceinc.com...&highlight=LSM
The Moroso valve seat pressure tester will be a lower price unit. We check new valve springs before they are installed with a Rimac machine at their verified installed height with their retainers in place. NEVER trust the published figures ! Once the baseline pressure is known from the bench tester we use a LSM tester and monitor them while on the cylinder heads. And note they can vary slightly as measured on the cylinder heads vs a bench tester. .
__________________
'70 TA / 505 cid / same engine but revised ( previous best 10.63 at 127.05 ) Old information here: http://www.hotrod.com/articles/0712p...tiac-trans-am/ Sponsor of the world's fastest Pontiac powered Ford Fairmont (engine) 5.14 at 140 mph (1/8 mile) , true 10.5 tire, stock type suspension https://www.youtube.com/watch?v=qDoJnIP3HgE Last edited by Steve C.; 04-27-2024 at 12:30 PM. |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
