FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
|||
|
|||
70-72 rear spoiler
Does the rear spoiler have a gasket where it meets the rear trunk lid? Or just the fiberglass just sit on top of the trunk lid?
|
#2
|
||||
|
||||
No gaskets.
|
#3
|
|||
|
|||
Sorry, thought I posted in the Firebird forum. I'll leave reply there in case they are still similar as GM used them across the board. They also commonly had a free spinning washer on the nuts that was caulked up. So if this doesn't apply, ignore.
#7583551 sealing washers were inserted between the spoiler and the trunk lid over each stud. Here's the reproduction version of the rear spoiler fastener kit, they decided to make smaller ones for the end nuts. https://momcp.com/wp-content/uploads...04/524-012.jpg Last edited by Trevor78; 03-03-2023 at 05:46 AM. |
#4
|
|||
|
|||
Sealing washers is correct sandwiched between.
|
#5
|
||||
|
||||
Has anyone ever seen a factory installed 70-71 Judge spoiler on a PHS or build sheet?
__________________
Mike/Illinois |
Reply |
|
|