#1  
Old 03-23-2022, 03:24 PM
tjs72lemans tjs72lemans is offline
Chief Ponti-yacker
 
Join Date: Oct 2017
Location: Winona, MN
Posts: 967
Default New rear sway bar install

I finally got my rear sway bar installed yesterday on my 72 Lemans. It came with two shims for each side, but there was no way they would squeeze between the trailing arm and bar. Is this normal? The ends were sticking away enough, but at the corner curve back the bar was already tight against trailing arm.

  #2  
Old 03-23-2022, 03:30 PM
Bruce Meyer's Avatar
Bruce Meyer Bruce Meyer is offline
Ultimate Warrior
 
Join Date: Dec 2001
Location: Phoenix, Az
Posts: 1,302
Default

You don't need to use the shims. If it fits without shims just bolt it up.

  #3  
Old 03-24-2022, 05:17 PM
tjs72lemans tjs72lemans is offline
Chief Ponti-yacker
 
Join Date: Oct 2017
Location: Winona, MN
Posts: 967
Default

Thanks. I was hoping that would be the case.

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:32 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017