| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
08-11-2008, 10:52 PM
|
||||
|
||||
is my 455 crank done?
i got a factory cast 455 crank that is 30 on the rods & mains. the mains will polish out but the rods may need to be turned. is it possible to offset grind it to the 4.25 stroke & use the 6.800 rods? had this done in the past but the cranks were all std.dont wanna throw it out i've always had good luck with the stock cranks thanks. Shaggy
|
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode