 |
|
| Performance Parts For Sale/Wanted Just Performance, non-stock, trailers, tools and related accessories here. |
| Reply |
|
|
Thread Tools | Display Modes |
|
#1
06-25-2020, 06:55 PM
|
|||
|
|||
WTB Round Port heads. Iron or Alum
Looking for a set of iron or aluminum round port heads. Would prefer bare but would take complete if the price is right.
|
|
#2
06-25-2020, 10:54 PM
|
||||
|
||||
|
|
|
#3
06-26-2020, 06:04 AM
|
|||
|
|||
|
i have a set of complete 7F6 heads here on this forum 2000.00 plus shipping
__________________
1970 firebird, 468, e heads, |
|
#4
06-26-2020, 02:42 PM
|
|||
|
|||
|
Sorry I should have specified that im looking for the smaller chamber heads. Have a 455 with 6.625 H beam rods and trw flat tops. Race only motor trying to get to at least 12 to 1 compression. Cans the big chamber heads be miller enough to get this compression?
|
|
#5
06-26-2020, 02:49 PM
|
|||
|
|||
|
Not without extensive work they can't.
Milling the 111cc+ heads enough to get compression throws the intake port alignment out of whack and messes with pushrod lengths.
You need a set of RAII or RAIV heads or some Edelbrock 72cc heads to get where you want to be. Edelbrocks will be less money and better flowing. And aluminum will be more sympathetic to the compression. Good luck. |
|
#6
06-26-2020, 03:39 PM
|
|||
|
|||
|
These are listed, http://forums.maxperformanceinc.com/...d.php?t=840618
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
