| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
 |
|
Menu
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
|
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
#1
01-17-2017, 04:45 PM
|
||||
|
||||
Repop Wheel Opening Molding Fit/Quality
So at the point where the wheel opening moldings are ready to be install. Repop fenders, the molding fits great. Quarter patch panels and repop molding, not so good.
The repop quarter patch panels fit pretty good to the outer wheel house/etc, so not sure where the disconnect is, maybe it's the rear repop moldings themselves? Wondering if I should send back the set of rear moldings and see if I get a better set? What have others seen in fitment of repop wheel opening moldings, and any tips or getting a good fit? .
__________________
. 1970 GTO Judge Tribute Pro-Tour Project 535 IA2 http://forums.maxperformanceinc.com/...d.php?t=760624 1971 Trans Am 463, 315cfm E-head Sniper XFlow EFI, TKO600 extreme, 9", GW suspension, Baer brakes, pro tour car https://forums.maxperformanceinc.com...ght=procharger Theme Song: http://www.youtube.com/watch?v=7zKAS...ature=youtu.be |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
