| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
08-13-2013, 09:47 PM
|
|||
|
|||
vert. alignment pin question
ready to strip my front header bow and noticed there was only 1 alignment pin.the other side has not been tampered with as far as i can see.no cage nut,no hole?? normal for the bow to have only 1?why 2 holes in the windshield header?
thanks |
|
#2
08-13-2013, 10:34 PM
|
||||
|
||||
|
Only one pin is correct, but I don't think there should be any holes in the header for the pin. Just a hole in the latch receiver bracket where the clamps attach. this is slightly behind the header & shouldn't go into the header.
I think the pin is just supposed to align the top from left to right to help align the latches as its closed, so no real need for two of them.
__________________
 68 GTO 4-spd Convertible 78 S/E Trans am L78, WS6 Auto 78 S/E Trans am W72, WS6 Auto 79 10th aniv W72 Trans am 80 Indy pace car Trans am 89 Trans am GTA Last edited by 68ragtop; 08-13-2013 at 10:39 PM. |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
