FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
||||
|
||||
![]()
Hey Everybody,
The carb ran out of gas with the pump being left off - then I surged the pump WITHOUT bumping it to fill the bowls - then it didn't seem to flood but it didn't run or sound clean - losing a 1 mph and a .15 ET in the 1/8. Thanks, Craig |
#2
|
|||
|
|||
![]()
Nah, check you plugs.
|
#3
|
||||
|
||||
![]()
Was this during a test & tune session , or into eliminations.
Either way how much time elapsed between the two runs?
__________________
Wernher Von Braun warned before his retirement from NASA back in 1972, that the next world war would be against the ETs! And he was not talking about 1/8 or 1/4 mile ETs! 1) 1940s 100% silver 4 cup tea server set. Two dry rotted 14 x 10 Micky Thompson slicks. 1) un-mailed in gift coupon from a 1972 box of corn flakes. Two pairs of brown leather flip flops, never seen more then 2 mph. Education is what your left with once you forget things! |
#4
|
||||
|
||||
![]()
Yes absolutely...... Did the engine seem crisp after the pass? ...... These new pumps can over fill the float bowl causing the engine to run rich until the correct level is maintained.
|
#5
|
||||
|
||||
![]()
I have shocked the floats once in the garage before but it bent the tab and flooded the motor - never running reasonably after - only either running or flooding.
After the pump issue it has never cleaned up the throttle response - run after run. |
#6
|
||||
|
||||
![]()
How is the float adjustment? I'd think if something went wrong from "shocking" the floats they wouldn't hold and adjustment.
|
#7
|
|||
|
|||
![]()
What does "shocking" the floats mean?
|
#8
|
|||
|
|||
![]()
I would like to know also ?
Is it possible to bend a float tab ? I have filled my bowls many times with the pump and the return regulator just by passes the fuel back to the tank. You would think something would have to be wrong with the regulator to bend a tab or something. |
#9
|
||||
|
||||
![]()
Bends the tabs if just turned on with an empty bowl WITHOUT BUMPING the pump first - otherwise pump and regulator are flawless.
Mark Sullens 1050 E85 dominator. |
#10
|
||||
|
||||
![]()
I will unload the car and check the float levels tomorrow - or sunday - DAMN BUSY!
|
#11
|
||||
|
||||
![]()
What jetting in your 1050, stock boosters?
__________________
Darby 74 Grandville 2Dr 455 c.i 4550# 2011 1.60 60 ft,7.33@94.55-11.502@117.74 2017, 74 firebird -3600 lbs (all bests) 1.33 60 ft, 6.314@108.39 9.950@134.32 M/T 275/60 ET SS Drag Radial 2023,(Pontiac 505) 1.27 60 ft, 5.97@112.86, 9.48@139.31.... 275/60 Radial Pro's |
Reply |
|
|