FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
||||
|
||||
Forward lamp wiring harness replacement
Very excited to be replacing my original forward lamp wiring harness, it should clear up a myriad of mystery issues that I’ve been dealing with. Been cleaning up and replacing ground wires throughout the chassis too.
95% of this job is super simple. However I’m sure there is a trick to removing the forward lamp harness boss from the firewall (behind the brake booster). Anybody here dealt with removing the block from the firewall lately? I found one article that says just pull it straight out from the firewall. Is that correct or is there a fastener holding it tight? I’m guessing there must be a screw or two hiding in the tar or whatever that gunk stuff is. It’s the block on the right in the photo. Thanks. Sent from my iPhone using Tapatalk |
#2
|
||||
|
||||
Figured it out. All I needed was a brighter light, lol
Sent from my iPhone using Tapatalk |
#3
|
||||
|
||||
Sometimes the best way to figure something out…..is to make a post on an Internet forum…..then and only then you’ll find that it wasn’t really all that hard to figure out after you looked at it again…..
__________________
1964 Tempest Coupe LS3/4L70E/3.42 1964 Le Mans Convertible 421 HO/TH350/2.56 2002 WS6 Convertible LS1/4L60E/3.23 |
#4
|
||||
|
||||
Quote:
Yeah exactly, especially here in everybody’s favorite department… electrical. Sent from my iPhone using Tapatalk |
The Following User Says Thank You to Vid For This Useful Post: | ||
Reply |
|
|