 |
|
| Pontiac - Boost Turbo, supercharged, Nitrous, EFI & other Power Adders discussed here. |
| Reply |
|
|
Thread Tools | Display Modes |
|
#41
07-30-2016, 04:08 PM
|
|||
|
|||
And Thursday the heads showed up.
|
|
#42
07-30-2016, 06:27 PM
|
|||
|
|||
|
Wow Tom, very neat. So they are a casting, not billet correct? Do you happen to have a pic that would show the profile as if you were facing the front of the engine? Are all the bolt holes for accessories cast there?
Also...and I don't mean to throw you under the bus in any way, and if you don't feel like answering I understand...what do bare castings cost? |
|
#43
07-30-2016, 06:39 PM
|
||||
|
||||
|
Wow those look pretty. Stout looking pieces.
|
|
#44
07-30-2016, 08:34 PM
|
|||
|
|||
|
The normal 6 holes are drilled and tapped on both ends. The 2 A/C mounting holes on the side above the exhaust area are not there. But there's room to add those lower down well under where the turbo mount pipes will be.
It looks tall, but keep in mind the sheet metal valve cover is very short. |
|
#45
07-31-2016, 12:56 AM
|
|||
|
|||
|
Quote:
All details about pricing and options are on the KRE website. Best you get that info there. |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
