[10secbird]

Has anyone used these wires?

They say "race fit - route over valve covers"

I take this to mean that they are short.

These wires sets are fully assembled and specific to make.

For those of you using these wires, how do you like them, would you buy another set?

Here is the p/n I'm thinking of ordering -

TAY-92016 - Taylor Race-Fit 9mm FirePower Ignition Wire Sets

http://www.summitracing.com/parts/tay-92016

[stroker461]

I use Taylor Thundervolt 50 10.4mm wires on the 461ci pontiac drag engine and msd 8.5mm on my sbc 388ci stroker in my hot rod pick up truck, both great wires No experience with those 9mm wires, but always look for the least amount of ohms per foot, msd and the thundervolt 50's are both 50 ohms per ft, moroso makes some that are 40 ohms per ft, but I like the thundervolt 50's on the Pontiac, hope this helps good luck. .....

[10secbird]

Thank you stroker -

[shaker455]

I ran them back in the day on my 2.8 v-6 89' Baretta.....they out lasted a car that went 280k.

Here's what I run on my 71' Pontiac:
http://www.summitracing.com/parts/mor-73802