 |
|
| View Poll Results: What are peoples thoughts: | |||
| Add some slots to allow the air out? |
   
|
0 | 0% |
| Add some square holes that are covered by flappers like what some factory shrouds have? |
  
|
1 | 100.00% |
| Voters: 1. You may not vote on this poll | |||
| Reply |
|
|
Thread Tools | Display Modes |
|
#1
03-08-2012, 10:09 AM
|
|||
|
|||
Slots in the Shroud or Flappers?
I am getting ready to swap my leaking stock radiator out with a new aluminum one I got.
I already have an electric fan with shroud and figure since I am making the swap I should consider adding some high speed flow through slots or flaps on to the shroud. In case I have not given enough details about what I am referring to: these allow air to pass through the shroud when you are driving down the highway because there is not enough pass through with the fan running. They also eliminate turbalance from the fan fighting the air being pushed through the radiator from driving 60-80 MPH. |
|
#2
03-19-2012, 12:39 PM
|
|||
|
|||
|
I think the flap method is better because: they will be sucked shut at low speed, thus allowing more air to be drawn thru the radiator......
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
