Power source for shaker hood scoop solenoids
Maybe someone can help me with this. I'm trying to install new solenoids into my '71 shaker scoop. When I installed the engine I ordered a new engine wiring harness from AMES (they said it was the "correct one" but you know how that goes). It only has the provision (male spade terminal) for the idle stop solenoid. I don't see a second one to power the carburetor switch that feeds the solenoids. I've looked in my '71 service manual, and can't find the wiring diagram for the shaker solenoids in the appropriate chapters. I know how the wiring runs from the switch to the solenoids, with the ground back to the firewall from the scoop. Does anyone know where the carburetor switch gets its power from? I assume the power is "switched," that is, it is only "hot" when the ignition key is in the "run" position. Any help is appreciated...
Alan
|