FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
|
The Body Shop TECH General questions that don't fit in any other forum |
Reply |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
WARPED DOOR PANELS
I have some nice original interior door panels that are warped. I have been trying to flatten them with a piece of plywood and weights for the past couple weeks and this process has not done a bit of straightening. Is there anything else that woud work or is it hopeless trying to flatten them?
|
#2
|
||||
|
||||
The reason for door-panels getting warped is water. So what you can do is spray them with water on the backside and then put them under pressure.
Hope this helps.
__________________
Hans Larson Sweden |
#3
|
||||
|
||||
I had this problem with my rear quarter panels on my 69. I found I had to get them quite water wet and then protected them with plywood and weighed it down with 20# propane tanks. After about two weeks for complete drying they came out great and went in the car. Hope it works for you.
|
Reply |
|
|