FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
|||
|
|||
Good Rule of Thumb Fuel Line
Hey,
Need to ask a question, replacing my old 3/8 tubing fuel line. What size to you suggest I use from fuel cell to filter, filter to pump, pump to reg, reg to carb. 650 hp 950 carb. later a 250 shot of Nitrous. Thanks |
#2
|
||||
|
||||
1/2" is what i used.
also keep in mind that most regulators have an inside oriface size of .220, which is less than 1/4" doesn't do much good to run larger fuel line if you run the small Holley regulator. i have the big Holley regulator, and it has a .437 oriface. |
#3
|
||||
|
||||
BTW, i bought my fuel line in an anodized blue roll made by Moroso for about $29
a buddy og mine found some plain silver aluminum 1/2" line at the local hardware store. i'm sure it was even cheaper. |
#4
|
||||
|
||||
-8an all the way at the minimum. make sure you run the same size return as the feed line if you run a return.
|
#5
|
||||
|
||||
the faster you go the more fuel you will need..... I run #12 up to front of car to regulators down to #8
|
Reply |
|
|