| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
11-30-2005, 06:12 PM
|
|||
|
|||
12 volt
I need to run a 12volt wire (ignition switched) to my new MSD coil. What is the closest wire to get into? I am told it needs to be #10 wire. 67 GTO 400.
Coil is on center of firewall. |
|
#2
11-30-2005, 06:25 PM
|
||||
|
||||
|
Got to ask some questions first...are you using a point-triggered system or some other ignition system with your coil? reason for asking is that some ignitions and points for that matter, need a resistor/resistor wire to the (+) side of the coil.
A 14 or 12 Ga wire will do fine without needing the stiffness of a 10 Ga. The easiest place to find the switched ignition circuit is at the bulkhead connector. It's reasonably close to the center of the firewall. george |
|
#3
11-30-2005, 06:30 PM
|
||||
|
||||
|
here it is in fact...
bulkhead conn.
|
|
#4
12-01-2005, 03:22 PM
|
|||
|
|||
|
Thanks again George!
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
