Performer RPM center divider mod. ???
i'm cutting down part of the center divider, to clear the throttle blade of a holley 3 bbl. so far, it's been marked off and a notch has been roughed in. since the top of the notch will now see some air/fuel flow, i'm wonder how to finish it off. i would think, it should be at least rounded. maybe a little knife edged would be good (don't want it too thin and risk it flaking). maybe it doesn't matter and leaving it square is ok. is there a preferred shape when doing this mod?
__________________
“We don’t build a ‘luxury’ car. We build a performance car then we make it luxurious.”
|
11-02-2022, 09:18 PM
Threaded Mode