Port alignment issue
I'm working on changing some stuff up a little and took off my offenhauser 5499 intake to replace it with oem 69 pontiac intake. I have edelbrock heads and the ports seem too tall for this intake. Obviously I don't have the gasket on here and was just dry-fitting. Once the gasket is there is this going to be an issue?
__________________
1967 GTO, 432 (428+.030), 4-bolt mains, factory Nodular crank, scat rods, icon dished pistons, Lunati HR 243/251@.050, .618/.622 lift, Edelbrock 72cc round port heads, 10.5:1, offy 2-4 intake, Edelbrock 650cfm carbs, Super T10 trans (2.64 first), BOP 10 bolt w/ Eaton posi and 3.36 gears
|