[Scott Stoneburg]

I know this has been talked about by several members. But I have finished working on my oil pump. I de-burred the gears and added the oil transfer dimple to all the gear teeth. Honed the exit shaft for the oil to remove casting flash and rough surface. Flattened the bottom plate mounting surface, and added a larger pick up tube. New pick up tube is 7/8" compared to the previous 5/8" tube. I had to open up the inlet of the pump in my mill. Only thing left to do is add the thicker bottom plate which should be here Tuesday. Then test the pressure and adjust/shim the spring tension if necessary.