| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
11-10-2013, 05:42 PM
|
|||
|
|||
Why are aluminum heads made with Boss
Ok, can,t figure it out, drivers side head towards rear of head outside there are 2 bosses sticking out with usually a hole in them, makes for torqueing head bolts back there a pain in the butt plus ive never seen anything ever bolted there.So way are they there????
You would think they would of been milled flat against head. I know if heads come off again thats what im doing.Where there located i can,t see anything bolted on there. They are flat on the outside and sure you guys know what i mean.Funny you don,t notice these things untill heads are bolted on!! LOL. |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode