FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
|
1982-92 TA & FB TECH 1993-2002 TA & FB Tech is now part of the new Late Model Section of the PY Forums. Click this link to check it out. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
I'm attempting to pull the motor out of the door.
Looks like there's four rivets holding the regular main frame (2 door). 1) I should leave them alone, right? There's another rivet down low. 2) I should drill that rivet out? Replace it with a bolt? There's three dimples in the sheet metal that are lined up where the 3 motor bolts are behind. 3)Do I drill these out to make access holes, then remove the nuts with a socket? 4)The motor would be totally loose then, except for the harness? 5)The motor comes out the upper access hole? The lower access hole is halfway blocked by the sector gear thingy on the regulator assembly. Thanks in advance.............Steve |
|
|