FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
|||
|
|||
For calculating compression, what's the bore diameter on the FelPro 1016 head gasket?
Also can I presume the stated .039" crush is close? Thanks.
__________________
'70 TA / 505 cid / same engine but revised ( previous best 10.63 at 127.05 ) Old information here: http://www.hotrod.com/articles/0712p...tiac-trans-am/ Sponsor of the world's fastest Pontiac powered Ford Fairmont (engine) 5.14 at 140 mph (1/8 mile) , true 10.5 tire, stock type suspension https://www.youtube.com/watch?v=qDoJnIP3HgE |
#2
|
|||
|
|||
For calculating compression, what's the bore diameter on the FelPro 1016 head gasket?
Also can I presume the stated .039" crush is close? Thanks.
__________________
'70 TA / 505 cid / same engine but revised ( previous best 10.63 at 127.05 ) Old information here: http://www.hotrod.com/articles/0712p...tiac-trans-am/ Sponsor of the world's fastest Pontiac powered Ford Fairmont (engine) 5.14 at 140 mph (1/8 mile) , true 10.5 tire, stock type suspension https://www.youtube.com/watch?v=qDoJnIP3HgE |
#3
|
||||
|
||||
Steve, Paul Spotts web-site shows the #1016 at 4.300 bore, .039" thick and 9.4 CC's compressed. http://www.spottsperformance.com/Gaskets2.htm
Robert Williams
__________________
"Three may keep a secret, if two are dead" ~ Benjamin Franklin ~ |
#4
|
||||
|
||||
When calculating the .039 should tell the story without the c.c. reading, correct?
|
#5
|
|||
|
|||
I`m getting .046 average for the 1016 Fel Pro gasket. Hope this helps.
|
Reply |
|
|