Ok I am ready to buy a turbo now that I bought a set of turbo manifolds that Jeff Palazzo/turbo69bird used to sell.
My combo is based off a long block Ken Keefer built for me.
It is a 70 455 block bored to 4.185 bore
SRP flat top forged pistons
Block is zero decked
Calculated compression ratio is 11.44-1
4 Bolt main caps
filled to the bottom of the freeze plugs
4.21 N crank
The heads are KRE 74cc Dports with the following flow
lift......Intake......Exhaust.....%
100....77.1..........62.6.........81.1
200....150.6.........114.6........76
300....204.9.........152.9........74.6
400....250...........177.9........71.1
500....288.2.........200.3........69.5
600....319.1.........226.6........71
700....336.8.........239.7........70.5
I would like to go with EFI, but may have to start with a blow thru carb. I do have a Victor EFI intake and fuel rails, but I would need injectors, throttle body, and then the software and I am sure there is more I will need for the conversion as well.
__________________
67 Firebird 467 cubic inches 7.71 @ 92 in the 1/8 and 11.69 @ 115 in the 1/4.
|