Quote:
Originally Posted by Half-Inch Stud
Hmmmm, so Vizard has a video about raising the floor about a Half-Inch, for nearly 25% CSA drop yet gets record CFM, HP, TQ, discharge efficiency, and BMEP.
Then he shows how to reliably epoxy (Goodman epoxy, or JB-Weld was deemed okaay) the floor, and grind to new shape. Also makes the pushrod bulge blind straight view to the bowl.
If you could mold around a good cfm silicone Intake form, then raise the floor & straighten the bulge to bowl ( toss uniform CSA a first) then see what the CFM (and noise) yields.
That would be great.
|
Mark,
Do you have any high end CFD software at work where this type of thing could be done?
Stan
__________________
Stan Weiss/World Wide Enterprises
Offering Performance Software Since 1987
http://www.magneticlynx.com/carfor/carfor.htm
David Vizard & Stan Weiss' IOP / Flow / Induction Optimization - Cam Selection Software
http://www.magneticlynx.com/DV
Download FREE 14 Trial IOP / Flow Software
http://www.magneticlynx.com/DV/Flow_..._Day_Trial.php
Pontiac Pump Gas List
http://www.magneticlynx.com/carfor/pont_gas.htm
Using PMD Block and Heads List
http://www.magneticlynx.com/carfor/pont_pmd.htm