what was the highest spring rate stock for our birds, trans am no air con.?
How about BBC. Camaro 2nd. gen Z-28 springs cut for height
I already have poly urethane bushings and I have run front 700lb. GT springs from guldstrand engineering with 1.1/4 sway bar up front and a 7/8 bar in the back with 160LB. rear leafs with a sub frame connector and solid body bushings
The car felt stable at any speed no floating around at 130 and the steering was great at that speed as well
wheels and tires were my limitation at that point and it rode like a truck I couldn't complain as I built it like that
so I have been around the block sort of speak I wont go stock rubber bushings again as I put them in one of my cars and they degraded in only about 3 years
I just want that fine line where you can tell there is some capability there over stock but no dump truck feel
thanks