Thread
:
55mm cam and simms timing chain set up
View Single Post
#
5
03-12-2024, 05:20 AM
chiefbigb
Ultimate Warrior
Join Date: Dec 2003
Location: richmond va usa
Posts: 1,490
I cut a small groove from the block oil hole to the front on the block under the cam bearing to get oil flow to the plate.
__________________
Be carefull of the feet you step on today.They may be attached to the a$$ you kiss tomorrow.
Reply With Quote
chiefbigb
View Public Profile
Send a private message to chiefbigb
Find all posts by chiefbigb