Tom,
First remember that this is just the results of a computer simulation.
Using 5300 RPM as a fixed point. If from that point on I keep the A/F a constant 14.2 and the BSFC is a constant .53, then using the VE and RPM from your dyno sheet with a 1.05 dyno correction factor. I get the following high end HP as shown on the graph with the HP and torque from your dyno sheet.
Stan
__________________
Stan Weiss/World Wide Enterprises
Offering Performance Software Since 1987
http://www.magneticlynx.com/carfor/carfor.htm
David Vizard & Stan Weiss' IOP / Flow / Induction Optimization - Cam Selection Software
http://www.magneticlynx.com/DV
Download FREE 14 Trial IOP / Flow Software
http://www.magneticlynx.com/DV/Flow_..._Day_Trial.php
Pontiac Pump Gas List
http://www.magneticlynx.com/carfor/pont_gas.htm
Using PMD Block and Heads List
http://www.magneticlynx.com/carfor/pont_pmd.htm
|