Fact: i have removed a 65-70s Big Car rear's Yoke and slide it onto a Chevy 12-Bolt pinion shaft input, finished the install and drove without failure nor leak. Did it again on every 12-Bolt thereafter. Go forth and enjoy.
Generally you could say Chevelles dropped driveshafts and GTOs chunked their differentials. But i happen to observe 2 GTOs drop their driveshafts at the rear yoke. I've been at the 1350 U-joint system since. And rims attached with Half-Inch Studs
Ueless Side note: The chevy Kingswood Estate Wagon 12-Bolt Posi rear is of amazing strength and parts sizes, and would come close to Dana60 dimensions. But i never got the Yoke.
Last edited by Half-Inch Stud; 07-13-2022 at 07:10 PM.
|