Quote:
Originally Posted by jm455ho
Drilled and tapped my KRE HP's for the center cooling mod. Decks are quite thick.
|
It's tough to tell from the photo, but if you haven't already drilled and tapped that port for a 3/8"-NPT male fitting, I think that you should. If you were to ever go to a -8 AN fitting in the center port, a 1/4" NPT x -8 AN fitting would have too small of a "Through Hole" due to the acceptable wall thickness at the 1/4" NPT end of the fitting.
BTW, I returned your E-Mail this morning....
Have a good one,
Larry S.
__________________
----------
http://www.pas4performance.com
Proud to Say, "Made in the USA"
----------