Agree that the Z-Bar is very much like my 64 GTO Z-Bar as far as the "look" and the "position" in the vehicle pics.
Mine was always a bit sung based initially on how the engine went into the frame mounts.
That being said, I finally put the end of the Z-Bar tube on a sander belt and dusted off about 2 mm of length and it was easier to go on then.
I also modded one (Upper Arm) to work with a set of JR Race Headers that went over the frame.
Believe there is a zerk fitting on the tube somewhere to add grease inside the tube.
Should also be seals that seal tube at block pivot ball and at frame ball. Been a few years since I played with it though.
Tom V.
__________________
"Engineers do stuff for reasons" Tom Vaught
Despite small distractions, there are those who will go Forward, Learning, Sharing Knowledge, Doing what they can to help others move forward.
|