08-19-2022, 12:32 AM
|
|
Ultimate Warrior
|
|
Join Date: Nov 2002
Location: ABQ, USA
Posts: 5,027
|
|
Work has been a bugger the last 2 months. Little time to work on the 71 other than pecks and paws.
Last month worked on sorting out the wiring harness while the engine is out.
Swap Time did a decent job but definitely room for improvement. Note once again this motor is a pretty new architecture that is kinda slow to catch on as far as I can see.
I cleaned up the wiring a bit, made a bracket to retain the harness under the front of the oil pan. The drawings are available for the asking. The OEM 2014-19 harness guide does not match the 2020 motor so it was trimmed back to fit better. I also will incorporate a couple extra wires in the harness for stuff like oil sender feed as I am running steam gauges currently.
|