[Stan Weiss]

Originally Posted by Baron Von Zeppelin

Its VERY hard to watch.
Was similar to watching and waiting for the grass to grow in February until its time to start the lawnmower in May.
At the 4 minute mark I was tired of it. And its an 18 minute video.
Forget it.

In 4 minutes time he didn't like the offset of the innermost intake ports.
And said no way possible they flowed anything close to 289cfm
The whole time all he showed was a head on a work bench displaying the exhaust side.
While talking about the intake port ?

Rocky Rotella flow tested the heads as cast.
We know who Rocky is.
Where is this guys flow test ?
He is purporting himself as a head porter - but can't flow test anything ?
Very impressive work , and sets the tone.

Click - Close

If anybody watched the whole thing and can add any value that was gained , just post that please.

I did watch the whole video. I don't own a set and have never seen a set other than pictures posted here. He did bring up some points I had questions about the heads from looking at the pictures posted here and some points about areas that I could not see because there was not picture of that area posted. He does show these areas and does point to what he calls problem areas.

Stan