[Steve C.]

Here is another build to serve as an example only, this engine built by Dave Bisschop....

.030-over 400
6X iron heads ported to 260 cfm at .550" lift / 9.3 compression
Comp hydraulic flat tappet cam
246 @ .050" intake duration
108 LSA
0.544" lift with 1.6 ratio rocker arms
Prepped model 3310 Holley carb (800 cfm)
1 -3/4" headers

On the dyno the Torker II intake with a 1-inch carb spacer made the most peak power- 459 HP at 6250 rpm with 451 ft.lbs. torque at 5000 rpm.
But the Performer RPM intake had a broader torque curve.

Now for conversation, and food for thought.... a set of 72cc Edelbrock heads with only a mild clean up would be in the 288-300 cfm area. And would be over 10:1 compression here.

.