".... low buck 455...Is there another inexpensive cam out there that may be a better choice?..."
From a low buck, inexpensive standpoint, I'd go with a Summit 2802 and some lifters & springs from Paul Spotts. The cam is $72.97 shipped. The lifters are $59 shipped. And the springs are $99 shipped. $72.97 + $59 + $99 = $230.97 Total
https://www.summitracing.com/parts/sum-2802
http://www.ebay.com/itm/New-Hydrauli...xZODlz&vxp=mtr
http://www.ebay.com/itm/VSH3-Pontiac...NW0LgK&vxp=mtr
If you still wanna go with an 041 clone, the Melling SPC-8 cam is cheaper than the Crower 60919. Many agree that all the 041 clones are made by CMC and sold under several different brand names. Today, the Melling is $109.98 shipped from an Ebay store.
http://www.ebay.com/itm/Engine-Camsh...RZMqws&vxp=mtr
Or, you can buy the cam & lifter kit, along with the springs listed above, from Paul Spotts, $175 + $99 = $274 Total.
http://www.ebay.com/itm/Pontiac-Ram-...1Uwp5F&vxp=mtr
As always, with an 041 clone, I'd prefer the Rhoads original lifters with the Super Lube option. But, they're $100 more than the Spotts liifters, and they make a ticking sound that many don't like.
https://www.summitracing.com/parts/r...w/make/pontiac
A few more cams that are in the same neighborhood, between the 2802 & the 041 clone are: Crane 283951, Voodoo 268, Crower 60243, and Howards 410051-14.
https://www.summitracing.com/parts/c...IaAusEEALw_wcB
http://www.lunatipower.com/Product.aspx?id=1776&gid=287
https://www.crower.com/camshafts/pon...m-284-hdp.html
https://www.summitracing.com/parts/h...w/make/pontiac
Not sure how much difference there would be between all these cams, on the dyno. I think Cliff Ruggles has posted dyno specs for the Crower cams, and Paul Carter has posted dyno specs for the Voodoo cams.
"... Edlebrock carb..."
"...I'd like all I can get and still run pump gas, be reliable ect..."
I'd dump that E-carb & go with a good 800cfm Q-jet by Cliff, SMI, or some other good Q-jet builder.