Thread: Engine Removal
View Single Post
  #1  
Old 12-15-2022, 07:33 PM
TxSportCoupe's Avatar
TxSportCoupe TxSportCoupe is offline
Member
 
Join Date: Aug 2021
Location: Wolfforth, Texas
Posts: 72
Default Engine Removal

If I’m working in a two car 21x21 l, 8 foot ceiling garage with my car parked straight on in the right bay, and I’m only pulling the motor and leaving the 350 auto trans, is there any reason I can’t just pick the 400 over the left fender of my Lemans? I know the fender is a couple of inches higher than the nose. But, I think I’ve got room. Was going to use a plate on the intake for the pull. Was thinking lift it a bit, roll the car back an inch or two, and , then straight up and back into the left bay. That way my disabled car stays indoors. I need to re-gasket the pan and possibly replace the rear main. Provided I can prove it’s leaking. I think it’s a pan gasket leak out the back door. Thoughts?


Sent from my iPhone using Tapatalk