I found a set of 4th Gen Camaro seats that recline and power driver seat - I used the 4th gen seat tracks.
I used the furthest back inside original bolt hole location to get best fitment and drilled and tapped the other three - outside rear and both fronts. I marked a line on center of the front two holes and measured back to make sure seat is square- I mocked up the fitment and it looks like I will use 1" blocks to lift rear to get the best seat track clearance. Looks like the outside front needs a 3/4" lift - front inside sits flush to the floor.
I haven't finished the install yet - dash is out - new interior going in with new carpet makes the seat modification install fairly easy.
I have another thread going and haven't finished the detail yet until I mount the seats and have the correct final specs and information for the best fitment.
https://forums.maxperformanceinc.com...d.php?t=872230
The power and recline will be nice.