Quote:
Originally Posted by darbikrash
I've seen engine dyno pulls using the TVS 2650 that put out over 1000 crank HP using E85, one in particular was on a 366 CID SBF.
No problem on the high impedance injectors, the below the blower, in the valley setup that is pictured uses Holley 100 lb/hr flow balanced injectors with EV6 connectors, which are plug and play for the Terminator X. The Injector Dynamics 1050 also fits.
No sure what you mean about the cooling lines, the air/water intercooler mounted in the blower does not share engine coolant, it has its own circuit.
|
I meant pulling water/coolant from the rear of the head to integrate into the cooling system. Looking at it again, I’m sure the extra lines can squeezed through to mate with the water crossover. It’s a cooling mod not related to the blower.
Cool. Those are the same injectors (holley 100lb flow matched) I’m currently using N/A on E85.